← Back to CVE intelligence
CVE intelligence

CVE-2026-89945

Vulnerability intelligence

Published Sep 16, 2026Sources checked Nov 10, 2026
N/ACVSS not listedScore unavailable
What this means

Review the available evidence

CVE-2026-89945. It is not in the current CISA KEV record we collected. That does not prove exploitation has not occurred.

What to do next

Remediation and response

Microsoft Security Response Center guidance

Vendor revision: Oct 21, 2026

Release Notes

Vendor-listed releases

  • 6.6.157.1-1
CISA KEVNot listedBased on the latest collected catalog
EPSS0.2%Estimated 30-day exploitation probability
Ransomware useNot markedCISA KEV ransomware field
Threat actors0Source-linked actor relationships
Overview

What is CVE-2026-89945?

In the Linux kernel, the following vulnerability has been resolved:

ASoC: cs35l34: drain threaded IRQ before runtime suspend

cs35l34_runtime_suspend() currently switches the codec into regcache_cache_only(true), asserts reset low, and powers the device off without first quiescing the threaded IRQ registered by devm_request_threaded_irq(). That leaves a window where cs35l34_irq_thread() can still run after suspend has removed live hardware access.

A running system can reach this during runtime PM while the driver still has critical fault IRQs unmasked. If the threaded handler runs in that window, it reads volatile INT_STATUS_1..4 after cache_only has been enabled, ignores the regmap_read() failures, and can still execute the PROT_RELEASE_CTL release sequence or the BST fault power-down writes.

Use disable_irq() before entering cache_only/reset-low/power-off so any in-flight threaded handler is drained and no new IRQ thread can run while the device is suspended. Re-enable the IRQ only after runtime_resume() has restored live register access with regcache_sync().

Since probe only logs request_threaded_irq() failures and keeps going, track whether the IRQ was actually installed before disabling or re-enabling it.

Source: NVD